Mach-E Forum | Ford Mustang Mach-E Forum and News banner

1 - 4 of 4 Posts

·
Registered
Joined
·
601 Posts
Discussion Starter #1
Today's update from a Ford engineer working on the Mustang Mach-E:

iorio_robert
Just a little fine tuning here and there. From the bright red dirt of our Brazilian proving grounds to driving around Shanghai, Spa and the Midlands, from the Anza-Borrego desert to Sweden, I've done some vehicle development in my day. Mach-E has been special and an honor to architect and engineer from Day 1. Every day a little closer.
2344

http://instagr.am/p/CEkyqYSHKXg/
Robert Iorio has been quite active on social media and I'm sure there are others.
 

·
Registered
Joined
·
601 Posts
Discussion Starter #3
Robert posted this earlier this week:

"Lots of space under the hood for checking and setting valve clearances, timing chain or belt replacement, cylinder scuffs, main, idle, air correction jets and emulsion tubes.....oh wait...none of that...just get in and drive the wild EV pony."

http://instagr.am/p/CE1xtZsHwDH/
 

·
Registered
Joined
·
498 Posts
I guess he figures he is clever and teasing/building up interest. I am neither amused nor aroused by his posts. I'll keep the rest of my opinion to myself.
 
1 - 4 of 4 Posts
Top